Quick Start Guide

Amebis System

Perform the following essential steps:

• Obtain software licence key from your supplier.
• Download and Install Amebis Control software from here.
• Set-up your MYSQL database. If you are using a networked version you will have received specific support on this process.
• Plug-in your Basestation using a USB cable (supplied).
• Install batteries into your Logger Caps.
• Launch Amebis Control Software
• Set up a Profile
• Enter your username and password. (To begin you can use admin as the username and admin as the password.)

When the Amebis Control Software opens set up the first run and tests as follows:

• Enter Logger and Sensor Cap numbers into the Amebis Control Software configuration section. Video Demonstration Here
• Create your first Profile. Video demonstration here.

You are now ready to setup runs and tests. Instructions can be found in the Amebis Control Software Manual under Help in software